NIPPLE CONNECTION G 1/2 MAX. 400 BAR, MAT. NO. 1.43305/ 1.4571

Fieldbus junction box for PMCprotego D (size 1.5 A to 24 A) Interfaces: CAN-in, CAN-out, RS232 with termination and monitoring voltage switch.

Servo amplifiers Technical data at 3x400VAC: Continuous output current: 4 A, Imax (5 s) = 7.5A Power consumption in S1 mode: 2.5 kVA Integral brake resistor

Set consists of connector X8Y Push in spring connection connector X4A Screw connection with tension sleeve for device to 24A

Fieldbus junction box for PMCprimo DriveP (size 1.5 A to 24 A) Interfaces: CAN1, RS232 and CAN2 with termination switch and RJ45 cable to connect the fieldbus junction box to the PMCprimoáC.

Cable assembled on both sides, Connector Sub-D9 male connector Sub-D9 female CAN network, length: 0.25 m.

connector X0Y Push in spring connection for device to 24A

Servo amplifiers Technical data at 3x400VAC: Continuous output current: 6 A, Imax (5 s) = 12 A, Power consumption in S1 mode: 5 kVA Integral brake resistor

Servo amplifiers Technical Details at 3x400VAC supply voltage: Permanent output current: 6 A, Imax (5 sec.) = 12 A, Power consumption in S1 operation: 5 kVA Internal brake resistor and mains filter additional hardware opRead more

suitable for the device series PMCprimo MC consisting of: X40a, X40b and X50a, X50b, X50c

consisting of connector X9 and shielded terminal for devices up to 24 A.

Expansion card with 14 inputs and 8 outputs can be used in PMCtendo DD4 & PMCtendo DD5 & PMCprotego.

Card can be used in PMCprotego Connector X5 (e.g. for Encoder emulation).

Use in PMCtendo DD4 and DD5 Interfaces: CAN-in, CAN-out, RS232 with termination and monitoring voltage switch.

Card can be used in PMCtendo DD5 & PMCprotego D.