text.skipToContent text.skipToNavigation

Programming


Have you finally decided to invest in the energy efficiency of your production equipment? The problem is: you are faced with the new pump, the efficient fan or the latest drive and all the controls do is: on and off?

Programming and setting up new components is not trivial, because it depends on the optimal integration into existing systems. Our experts are concerned with getting the best out of the existing configuration even without extensive new installations. Our technicians know the appropriate function module and integrate it into your control program, setting the right parameters so that the system runs smoothly and safely, saving energy and reducing CO2 consumption.

​​​​​​​This applies to new systems as well as to the implementation of individual components or as part of re-engineering projects, for motion controllers, frequency converters or servo amplifiers: Our team also gets the most out of your system during programming.

​​​​​​​Use our contact service on this page and get in touch immediately with one of our technicians. We are happy to help you.

You might also be interested in this:

Parameterization
Today, hardware and software are two components of a unit that can no longer be separated. As a consequence, it is no longer enough to keep an eye on the physical world. After properly cabling and connecting a component, fine-tuning begins. Only the right settings in the software get the most out of the systems.
Read further
Pneumatic re-engineering
Our re-engineering of your pneumatic system starts with an inventory. Here, we first look at the compressor. Then we also check the pipe network, couplings and hoses needed to control the pneumatic components. If certain components need to be replaced by new versions, this will be mentioned in the report.
Read further

You are probably also interested in these product groups:

Explore our competences, services and solutions for your success: