You searched for "CADDY"

Supports conduit from beam. Requires only a hammer to install.

Use with 24SC series snap clips to accommodate thicker flanges. Supports up to three snap clips. Requires only a hammer to install.

Supports cable to decking. Snap clip that attaches to decking. Mounts in two different orientations. Fits in any 6 mm or greater hole.

Used to support cables from beam flanges. Requires only a hammer to install.

Supports single run of cable. Attaches easily to beam or joist.

railverbinder; stompe hoek; 2-2; 87mmx87mm

Requires only a hammer to install. Available for EMT, rigid and aluminum conduit. Will pivot thru 360°.

Geprefabriceerde assemblages kunnen gemakkelijk worden opgetild en op hun plaats worden vastgezet, waardoor tijd en geld wordt bespaard. Eenvoudig “aanduwen-om-te-installeren”-ontwerp stelt installateurs in staat om de dRead more

Designed to reduce wire rope fraying.

Suspends threaded rod from beam flanges. Threaded rod hanger can swivel to provide a vertical dropdown. Requires only a hammer to install.

Designed to protect paint on steel flanges.

Square adapter nut for Wide Mouth Steel C-Clamp. Exact fit into C-Clamp; nuts do not twist during installation.

Provides an attachment for wire, S-hooks, chain, nVent CADDY Speed Link or other assemblies to flanges and profiles. Fits most beams. Installs with just a hammer.

Provides superior support for pipe, conduit, duct, cable tray and equipment. Foam bottom offers low abrasion interface for better roof membrane protection. Compatible with roof surfaces including single ply, bituminous, Read more

One-piece cable/conduit clamp with protective boot. No screws or bolts to drop. Requires only a screwdriver or nutdriver for installation. Fits into open side of strut channel.

Supports electrical fixtures from acoustical T-grid. No tools required for installation. Fast, easy and secure twist-on installation. Designed to reduce scratching of T-grid. Wing nut included.

Pijpbeugel 56-61mm M10 RVS/EPDM ZW

Supports conduit/pipe or cable from beam flanges. Snap close clip pivots a full 360°. Requires only a hammer to install.

Supports conduit/pipe or cable from beam flanges. Snap close clip pivots a full 360°. Requires only a hammer to install.

Easily supports cable from flanges. Requires only a hammer to install.

Provides an attachment for wire, S-hooks, chain, nVent CADDY Speed Link or other assemblies to flanges and profiles. Fits most beams. Installs with just a hammer.

Supports conduit/pipe or cable from beam flanges. Snap close clip pivots a full 360°. Requires only a hammer to install.

Easily supports cable from flanges. Requires only a hammer to install.

Easily supports cable from flanges. Requires only a hammer to install.

Suspends threaded rod from beam flanges. Threaded rod hanger can swivel to provide a vertical dropdown. Requires only a hammer to install.